Implagraphy Safety Operation Manual

Implagraphy 3-in-1 Dental Imaging System (CBCT / PANO / CEPH)

7/5/20251 min read

1. Authorized Personnel Only

  • Only trained and certified professionals are permitted to operate or maintain this equipment.

  • Do not open the device housing or attempt repairs unless you are an authorized technician.

2. Radiation Protection

  • Always use lead aprons to protect patients, especially children and pregnant women. Consult with the physician if necessary.

  • During X-ray exposure, the operator must remain at least 2 meters away or behind proper shielding.

  • Never allow the laser beam to enter the eyes of patients or staff.

  • Ensure the room where the equipment is installed complies with local radiation protection regulations.

3. Electrical Safety

  • Turn off the main power when the system is not in use.

  • Always unplug the power cable before cleaning.

  • Do not run cables near heat sources or use extension cords long-term.

  • Ensure the equipment is properly grounded.

4. Hygiene & Disinfection

After each patient, disinfect the following components:

Tip: At the end of each day, wipe down the outer casing with a soft, dry cloth. Do not use detergents or abrasive cleaners.

5. Patient Preparation Guidelines

  • Instruct patients to remove all metallic objects (glasses, earrings, retainers, dentures, etc.).

  • Ensure proper head stabilization using ear rods, chin rest, nose locator.

  • During imaging, the patient should remain still, with eyes closed, tongue against the palate, and breathe through the nose.

6. Emergency Procedures

  • The unit is equipped with a red emergency stop button. Press it immediately if there is any malfunction or patient distress.

  • In case of abnormal operation (e.g., water ingress, overheating, electrical smell), power off immediately and contact technical support.

7. Environmental Requirements

  • Recommended room temperature: 20–25°C

  • Relative humidity: 10%–90%

  • Atmospheric pressure: 700–1060 hPa

  • Install the system in a clean, dry, well-ventilated area, away from dust, chemicals, moisture, vibration, or strong reflective light.

8. Prohibited Actions

  • Do not modify system parameters or place objects on the device.

  • Keep the rotating unit's movement area clear of obstacles.

  • Do not use the machine in environments with high oxygen or flammable anesthetics.

Component

Medical alcohol (76%) wipe

Steam sterilization at 134°C or low-temp sterilization

Medical alcohol wipe

Recommended Disinfection Method

Chinrests, Bite Blocks, Temple Supports

Panoramic bite blocks

All contact points (handles, supports)